Building 32-bit on 64-bit Linux without jprt.config?
David Holmes - Sun Microsystems
David.Holmes at Sun.COM
Wed May 20 22:40:08 PDT 2009
Sorry that flag should be LP64=1
David Holmes - Sun Microsystems said the following on 05/21/09 12:40:
> jprt.config is used by our internal build/test system so I don't know
> why your changes were made there. Anyway the main changes would be in
> the top-level makefiles (possibly top-level of each sub-repository).
> I've only done this for hotspot and then in an older version of the
> system. But the basic approach, as I recall, was to emulate the solaris
> approach and just make sure if LP=64 (or equivalent) is not set then use
> all the necessary 32-bit flags.
> Ironically my changes were not applied to the JPRT side of things :) - yet.
> David Holmes
> Nicholas Riley said the following on 05/21/09 12:20:
>> For a while I've been patching jprt.config to build 32-bit on a 64-bit
>> Linux machine, as was discussed back here:
>> The exact patch I was using is:
>> However, there's no more jprt.config in make or corba/make. Where
>> else would be a good place to make this change now?
More information about the build-dev